2 link DIY Axle Brackets (4 pieces) Size:3" Standoff These brackets are lower profile

These brackets are lower profile to get the bag closer to the axle

so no custom machining is needed

These fittings will allow you to tie our accumulators into the system with a 3/8” NPT male on one side and a #8 ORB on the other side to go into accumulator

you just install a donut with your cylinder

making the cylinder go through the frame without any funky angles or abnormal side loads

2 link DIY Axle Brackets (4 pieces) Size:3" Standoff These brackets are lower profileFor those of you making your own 2 link, these brackets are used to bolt to the link bars and weld on to the axle. Slotted so you can adjust axle front to back. The short brackets have a standoff of 3" from the bottom of the axle to the center of mounting bolts. The tall brackets have a standoff of 5" from the bottom of the axle to the center of mounting bolts. (EACH SET COMES WITH 4 PIECES)