Sherline Lathe Live Center Part Number 1191 Pipe Bender American Sun 3/8" End Mill

American Sun 3/8" End Mill HLR

Cutting edges designed to cleanly cut all types of wire: soft wires and modern materials to a maximum piano wire specification of: 2mm 210 kg/mm²

Precision matched Vee block set with two 90° V’s of different capacities

With a barrel-shaped red-stained birch handle and a 2

The stock has thick brass facing on its inside face

Sherline Lathe Live Center Part Number 1191 Pipe Bender American Sun 3/8" End MillThe Sherline lathe comes equipped with two dead centers that fit the headstock and tailstock. These centers are used for holding parts that are mounted between centers. This system of mounting work in a lathe has been in use for many years. However, since the tailstock center is held stationary and does not turn with the part, it is a point of friction and requires frequent oiling and attention. Also, because of thermal expansion caused by friction