LC29H(BS) GPS/RTK HAT for Raspberry Pi _MAKE_COMP_OTHER It's ruthless watchy oneupmanship and

It's ruthless watchy oneupmanship and we don't want you looking second best

You can even include your favourite SparkFun libraries and use them as if you were running the code on a RedBoard

There's a constant current backlight control circuit using the TPS61169 which can get up to 30V forward voltage and can be configured for 25mA-200mA in 25mA increments (default is 25mA)

the pin order is: GND

FL connector at the rear of the board

LC29H(BS) GPS/RTK HAT for Raspberry Pi _MAKE_COMP_OTHER It's ruthless watchy oneupmanship andThis GPS RTK HAT can track dual frequency L1+L5 GNSS signals, substantially reducing multipath interference in urban environments and enhancing positioning accuracy. This module is compatible with Raspberry Pi series boards and Jetson Nano through its standard 40 pin GPIO extension header. It supports concurrent reception of multiple GNSS systems, including GPS, BDS, GLONASS, Galileo, and QZSS, which enables it to provide consistent and low power