3D Prints NW - Polaris P-22 Clutch Holding Tool Billet Throttle Block Lose over 0

Lose over 0

Ski Doo Carbon rails require our carbon axle or similar to fit 1 inch axle slot

This design allows for a better response to rider input by eliminating the "flex" of stock running boards

ZBROZ - Ski Doo Gen 4 / Gen 5 T-Motion Lockout

and XM are all pre drilled to accept the Ultralight Rail Brace

3D Prints NW - Polaris P-22 Clutch Holding Tool Billet Throttle Block Lose over 03D Prints NW Polaris P 22 Clutch Holding Tool This is a 3D printed tool designed to hold your primary clutch without marring it up like a metal holding tool will do on the Polaris P 22 drive clutches found on the Polaris Boost and 9R. These are for use while doing the re torque ONLY, not the initial 150 ft lbs. It should withstand that high of a torque, but it is not advised. See notes below. ***BACK IN STOCK*** ***This tool was 3D designed to fit