Hakko Soldering Tip: T18-S4 Fine SMD - For Lead or Lead-Free Use _RPI_HAT_MotorServo It measures less than 10

It measures less than 10 cm on each side and weighs approximately 300 g with an Arduino Uno and batteries (165 g without

This version does NOT have a touchscreen attached

The Raspberry Pi Sense HAT V2 is attached on top of the Raspberry Pi via the 40-pin GPIO pins (which provide the data and power interface) to create an ‘Astro Pi’

MCR12 Barcode Scanner Specsheet

The 1-Wire® port on the 1 Wire Pi Zero is based around a DS2482-100 I2C to 1-Wire® bridge device

Hakko Soldering Tip: T18-S4 Fine SMD - For Lead or Lead-Free Use _RPI_HAT_MotorServo It measures less than 10Upgrade your Hakko with a new tip, you'll get better & faster solder joints and the whole process will be much more enjoyable. This tip fits the FX 888 analog and digital irons, and they're fast to swap, takes only 30 seconds to change out. All the tips are good for either lead or lead free (simply set the iron to the temperature required for the solder you are using). This is a "Fine Point" tip, great for any SMT soldering and other delicate work.